2020. 2. 28. 13:11ㆍ카테고리 없음
Hp Ilo Firmware Dl380 G4 Cpu Problems
We have an old DL380 G4 that we are just using for a secondary DFS host. We renewed the support on it. Can I get an Updated ILO on it?
It currently has 1.82.It has two MAS60 Drive Arrays attached, so will it take down the server OS (2008 R2) and the arrays while doing it, or will it just reset the ILO controller and DFS will still function?I have not used ILO or DRAC before, let me know thanks.Any Cavet for doing firmware on this older system, other than the fact it is old and I just have to pray to the firmware gods? For what its worth, I have been updating a lot of our servers here (many are DL360 and 380 g4's) with the update disk. Some of the ILO firmware was older then what you are at, some of the bios were at factory level.No issues for me.Also, ILO is very handy, even if you don't have full capability, like remote console. I'd suggest hooking ILOs and DRACs up and familiarizing yourself with them, as you never know when you might need them.Also, to make it easier to get to them, add DNS entries with names like 'iserver' (like I for ILO, servername). Can be real handy.Let me know if you have any questions. Dukat is correct. ILO is always able to be updated whether you are in warranty or not and whether you have support on the iLO or not.The only difference is if you call in for support on an iLO Advanced feature (LDAP, Remote Console, Scripted Virtual Media, etc) and you do not have support, you might not get help.But basic functions of iLO are covered under the System's warranty/support since iLO Advanced is not a required piece of software.
So if basic iLO functions are not working, you should still get help from HP since you said the support on the server itself was renewed.
Got a used HP ProLiant DL380 G4 server. It was at least able to start from an Ubuntu live CD a few days ago. When I connected the iLO-port to a router with DHCP server iLO 1.62 was accessibly using the web interface and SSH.Cleared the NVRAM (the wrong way):. unplugged power. set S6 of system maintenance switch. plugged power in again. started server.
shut down server. unplugged power. unset S6.
plugged power in again. started server with 'Firmware Maintenance 8.5' in DVD driveFrom this time I could not connect to iLO with web interface and SSH.
The iLO does not get an DHCP IP while other computers when connected to the same router have no problem. Only the yellow iLO port LED is on.A monitor did not even wake up when connected to the video. A USB key drive did not show activity when the server was turned on.When off the iLO status LEDs flash like this:- 1, 3, 4, 6, 8 together- 5, 7 together- 2 offWhen starting the server this LEDs are on:- 2, 8- after about 15 s: 3, 4In the User Guide HP writes 'iLO diagnostic LEDs Refer to the HP Integrated Lights-Out User Guide'. But apart from a special case with LED 4 off I could not find further information there.Does anybody know something about the meaning of the iLO diagnostic LEDs?Any other suggestions?